Taco Marine Logo
Application Support: Knife & Pliers Holder
Knife & Pliers Holder

Knife & Pliers Holder

Knife & Pliers Holder

Note: Please print design template at 100% for accurate sizing. Slight scaling may still occur. Therefore it is recommended that all template dimensions are measured for accuracy before using. This should not to be used as a drilling template unless dimensions are checked.

Materials List:

  • 1 -P10-5012WHA27-1 12"x27" Marine Lumber Sheet
  • 6 -#10 x 1" Stainless Steel Wood Screws

Step-By-Step

  1. Cut out all three templates and trace them onto the starboard with a wax pencil
  2. Place the upper and lower plate templates along one long edge of the marine lumber
  3. Mark the notches for the knives and the oval for the pliers and cut them out
  4. Now cut the three templates from the starboard
  5. Bevel all edges except the long edges on the upper and lower plates
  6. Drill the 1/8 holes in the back plate to hold the upper and lower plates
  7. Countersink these holes from the back
  8. Drill the four mounting holes and countersink these from the front
  9. Attach the two plates to the back plate with the stainless steel flat head screws
  10. Now you can mount the completed unit at a convenient location using the four mounting holes and stainless steel flat head screws