Taco Marine Sport Fishing Catalog - page 40

40
Call 800.226.8201 Boat Builders & Accessory Manufacturers
Call 800.653.8568 Aftermarket Distributors
TacoMarine.com
Rigging an Outrigger
Single Rigging
The pad eyes that the bungee hooks to
on the gunwale is usually installed about
6" toward the stern between the outrigger
holder and the rod holder. On the T-Top the
pad eye is usually hooked on the outer t-top
ring so it can be easily reached.
Apply small amount of tape in
middle of line bundles (to avoid
fraid ends).
Cut the bundles of line into 2.
Run the outrigger line up through
each of the eye guides from the
bottom up to the very top eye.
Pass line through float and then
through the barrell sleeve,
through the snap swivel
assembly and back through the
barrell sleeve.
Tie a double knot and then
attach the release clip to swivel
assembly.
Using the other end of the line,
run line through the pulley.
Run the line through the barrel
swivel, through the snap swivel
assembly and back through the
barrel swivel.
Tie a figure 8 knot and adjust
slack as needed. Attach swivel
assembly to the release clip.
Secure pulley/bungee assembly
to pad eye. Remove slack by
sliding the lock swivel down
and/or cut off excess line on the
outside of locking swivel.
Loop must be
12" - 24"
Float
Barrell
Sleeve
Snap
Swivel
Assembly
Adjustment
Screw
Release
Clip
Barrel Swivel
(Removes Slack)
Premium Standard
Pulley or
Glass Eye
What is trolling?
How do I use my outriggers?
reference - Rigging
1...,30,31,32,33,34,35,36,37,38,39 41,42,43,44,45,46,47,48