Taco Marine - Projects Guide - page 24

24
Sportfishing Equipment
If your top does not already have a
mounting plate, TACO’s new Clamp-
On Mounting Plate is an easy addition
to add outriggers, antennas, lights and
radar. The clamps capture both the plate and the top’s pipe. Inserts are included
to fit 3/4” and 1” round pipe and oval pipe. The plate comes in standard 30” length
and can be cut to length required. TACO’s Clamp-On Mounting
Plate is available pre-drilled to accept the Grand Slams or the Sport
Slam.
TACO CLAMP-ON MOUNTING PLATE
STRIKER BASES
The Striker gunwale mount is usually positioned toward the bow
of the boat at least one foot in front of the last rod holder. You will
need to cut a hole for installation. Visit tacomarine.com for drilling
template. Use a 1-1/2” or 2” hole saw & cut a 45 degree angle,
then file to get a perfect fit. Use a sealant such as 3M 5200 under
the plate for a watertight seal. The gunwale mount comes in two
sizes: 1-1/8” ID and 1-1/2” ID Backing Plates should be used on
gunwales 3/4" or less in thickness. Striker Bases are
also available in a T-Top model with 90° swept back
arms
Striker base
F16-0212-F • F16-0150-F • F16-0212-T
TACO’S STAINLESS STEEL SNAP-LOCK
ROD HANGER
1. Lay rods in holder on deck for proper mounting
positioning
2. Fasten mounting piece to surface using # 10
stainless steel self-tapping screws
3. Place TACO rod hanger onto mounting piece and
screw in set screw until tight
4. Slide butt end of rod holder into the closed ring then
insert tip
Snap-Lock Rod Hangers
w/ Stainless Steel Spring
F16-2700-1
STAINLESS STEEL REEL HANGERS
1. Lay rods in holder on deck for proper mounting
positioning
2. Fasten mounting piece to surface using #10
stainless steel self-tapping screws (not included)
if mounting to a round surface, you will need to
fabricate a spacer as shown in photo on right, to
the outside diameter of the pipe.
3. Place TACO reel hangers onto mounting piece.
and screw in set screw until tight
4. Slide the tip into the rod holder
5. Insert reel into holder by compressing the spring pins
GSE-1001-1 • GSE-1002-1 • GSE-1003-1
Patent Pending
Snap-Lock Reel Hangers
F16-2800-1 • F16-2810-1
F16-2820-1
1...,14,15,16,17,18,19,20,21,22,23 25,26,27,28,29,30,31,32